Crafty Sewing Time-Pocket Wall Hanging

A few days ago, I was looking through Amazon trying to find something I could hang on the wall of my craft room that had pockets.  I had been using my daughter's old hanging jewelry organizer. It was working okay, but I decided to reorganize my supplies to be more efficient, and it was simply taking too much room.  As I searched Amazon and Google shopping, I realized I could make something!  So, I did.  These are the fabrics I used.

Pink print at the top as pockets, pink roses for the main front, and solid pink for the slip pocket and back.

I didn't create a pattern.  I just knew I wanted to start with 12x14 fabric, one for the front, and one for the back.  I knew I needed interfacing, so I ironed it on the wrong side of the front fabric.  I wanted four pockets, and I wanted them shaped like the bottom half of a stop sign, like this...

This would give them some shape and more room because instead of sewing it down in that shape, I scooted the sides in until they were almost vertical, pinned, and sewed.  I decided I wanted a slip pocket at the bottom.  I just ironed some interfacing in between two 12 inch wide pieces of fabric then sewed some leftover bias tape along the top edge of the pocket.

I decided to make ribbon tags to hold the woodent dowel, and I used the ribbon as a hanger as well.  When the four pockets were finished and the ribbon tags pinned.  I put the two main pieces with right sides together and sewed all the way around the rectangle except for a small space to use for turning.

After sewing and turning, I pressed my wall hanger.  Then I topstitched about 1/8 inch all around making sure to catch the open seam I had used to trim it. I love how it turned out!  All I had to do was put the dowel through the tabs then take one long piece of ribbon and tie it to both ends.  It's ready for hanging!

The exact materials are listed below.  They are affiliate links meaning if you choose to make a purchase, I may receive a small commission at no cost to you.  This is NOT a sponsored post.

Materials:

front fabric 12x14

back fabric 12x12

4 smaller pockets with 3 inch bottom (came from the same bundle as front fabric)

slip pocket fabric (same as back) 12x4.5

Bias Tape (optional.  I already had some that matched)

Interfacing

Grossgrain ribbon

Wooden Dowel 12x3/8 inch

Thread that matches

Sewing Machine

Fiskars Fabric Scissors

Press Perfect Hot Ruler (This might be my favorite sewing supply.)

Pins or Clips

Iron and Irony Pad or Board

For other crafty posts, link up with Crafty Creators or Happiness is Homemade.